At this time of Chair hardware should be flat or flip open, chair hardwares include shaft to open chairs or hinge and the chairs shut device such as pin.In order to improve the chairs the wind strength, it is widely used outside the chairs. But hinge must be exposed outside the chairs, the wind and rain erosion resistance of hinge became a problem. Now some of the more than one hundred old buildings in Europe, you can also see 10 times larger than present ordinary hinge of metal hinge, the hinge on the style and ancient European construction is harmonious.Outside the chair hardware of the another question is to prevent the casement of open type in free violently movement under the action of wind, so have the so-called limiter, the limiter in many ways are prone to failure parts. Chair Hardware,Aluminum Die Casting Chair Hardware,Chair Hardware Parts,Chair Accessories Hardware NINGBO ZHENHAI BOLANG METAL PRODUCT FACTORY , https://www.aldiecastings.com
Since the indoor ventilation system normally operates for 24 hours, the bearing is required to be energy-saving. In addition, the bearing is also required to be quiet because it is set in a bedroom or the like in the home. Once the inside of the bearing enters the dust, it will generate an abnormal sound. Therefore, in order to achieve silence, dust prevention is an important link.
The contact-type sealing lip is in contact with the inside, so that although the dust-proof performance is superior, the friction loss increases. The non-contact type seal lip is not in contact with the inside, so it is superior to the contact type in terms of friction loss, but the dust resistance is slightly inferior. Therefore, in the new products, improvements were made to compensate for various types of defects.
In the contact type, the rigidity of the sealing lip is optimized by computer analysis. Without loss of high dust-proof performance due to gasket contact, the friction loss is reduced by about 30% compared to the original product. As a result, the power consumption of the fan motor can also be reduced. In the non-contact type, based on the improvement of the gasket and the internal design, the use of rubber gaskets minimizes the gap. The dust resistance is improved without losing the low torque performance, and the quietness is improved by about 2 times compared with the original product.
Seiko Co., Ltd. has developed a bearing for indoor ventilating systems such as ventilation fans - "deep groove ball bearings with low torque and high dust sealing." The bearing has two types, contact type and non-contact type. Sample shipments are now available. By reducing the dynamic friction loss and improving the dust-proof performance, energy-saving and noise reduction are realized.
November 26, 2024