While a pot is not actually a shape per se, the Hope Pot Magnet category includes block and disc magnet shapes as well as magnets that contain Ceramic, Neodymium and Alnico magnetic materials. Pot magnets combine these shapes and materials with a steel casing that covers the exterior of the magnet to form an assembly with more magnetic strength and far more durability than standard magnets. The metal casing protects the brittle magnet from damage and simultaneously increases magnetic field strength by deflecting most of the field downwards to the uncovered base. The result is a magnetic holding tool that is versatile, highly effective and in many applications is far more practical than fasteners or glues.
China Pot Neodymium Magnet,Small Pot Rare Earth Magnets,Super Strong Pot Magnets Manufacturer,Small Pot Magnet,Small Pot Magnet Supplier Ningbo Hope Magnet Co.,Ltd , https://www.nbhpmagnet.com
Self-operated pressure control valve does not require other external energy sources such as power, gas source, the media alone to drive their own energy, energy saving and environmental protection, easy to use, set the pressure value after installation can be put into automatic operation, so in The control accuracy is not high, but also the lack of power, gas source of the occasion, has been more widely used. However, this valve also need to properly select the correct type and installation, use, to ensure that put into operation without any problems. Needless to say on the selection, such as the control valve is used to control the pressure before or after the valve pressure, the medium is room temperature or high temperature, whether corrosive, the maximum working pressure, etc., we must first figure out, we mainly talk about Talk about the installation and use of the issue. Because I recently encountered a case of self-service pressure regulator valve problems, very representative. Valve is used in the steam pipe, put into use just a month or two, the user on repair. A look to the scene, a lot of steam from the diaphragm vent valve discharge, noise, amazing momentum. The cause of the accident, obviously, the steam has not been condensed, directly into the membrane head, burned the diaphragm. Self-acting pressure regulating valve for steam pipe, the installation must be between the actuator and the pipe plus a condensate tank, the steam can not get into the actuator membrane, and, the control valve must be installed head-down, condensate tank to be higher than Film head, initial use, be sure to condense the tank and film head filled with water. Look at the installation site, on-site instrumentation staff, these are no problem, then what caused it? It is puzzling. Later, I carefully asked an operator, who inadvertently learned: This valve is installed, put into use, the condensate tank and the film between the brass fittings has been intermittently leaking. The original is the case, the water leakage led to the condensate tank slowly leak light, steam into the membrane head, burned the diaphragm. Thus, self-acting pressure regulating valve in the steam pipe when used, installation, maintenance must pay more attention to, in order to ensure the normal operation of the control valve, do not allow joints leaks, condensation can not be allowed to water, regular inspections, Timely water. In fact, not only self-pressure regulator, is the other self-regulating valve, also need to pay attention to the use of maintenance and care Caixing. In addition, if the steam pressure is higher, the best choice of piston actuators, rather than take the film actuator, because the diaphragm can withstand the pressure of not more than 0.4Mpa, though this can be used, but must greatly reduce the service life.
June 23, 2024