Vibration plate troubleshooting

Possible causes of vibration disk not working
1. The power supply voltage is insufficient 2. The connection between the vibration disk and the controller is broken 3. The controller fuse is blown 4. The coil is blown 5. The gap between the coil and the frame is too small or too large 6. There are parts stuck between the coil and the frame 7, the vibration plate against a hard object, a top plate or chassis encounter other devices <br> <br> vibration plate vibration fatigue or too slow, or irregular feed sporadically, may be due to:

1. Spring break 2. The floor is too thin 3. The mounting table is defective and lacks hardness. If it is suspended on the equipment table, the vibration will be too weak, the thickness of the table should be at least 1-1/2 ", so that it will not absorb vibration. The cylindrical support must be equipped with triangular support.

4. The table is not horizontal 5. There are debris 6 in the dish. The air gap of the coil should be as small as possible 7. Excessive machine rhythm causes the part to slip from the vibration plate.

8. Power grid fluctuations 9. The controller needs to be readjusted to adapt to grid fluctuations.

10. Parts problems: poor, curved, oily, etc. 11. The fastening screws of the disc and the base are not tight or in the wrong position.

12. Too many parts 13. Improper chassis adjustment 14. In the event of a material change, the disk should be reconditioned and the chassis 15 readjusted. In the case of using air blowing, there may be some problems, may exist: air pressure instability, air pollution, water or oil, these contaminants will stay on the surface of the vibration plate, leading to slow or even not feed the speed. The gas source must be clean and dry, equipped with an independent pressure regulator and filter. Do not use rigid tubes to reduce feed performance. Flexible hoses should be used.