Water Purifier Installation Operation and Maintenance Knowledge

Water purifier installation operation and maintenance knowledge Installation space: Choose a suitable space location, according to the actual size of raw drinking fountains and pre-filter, be sure to leave space for replacing the filter.

Both the drinking machine, the pre-filter and the filter element must be mounted vertically on a wall that supports their working weight and must not be turned upside down. The installation pipeline should be as short as possible. The inlet and outlet connectors must be connected in the direction indicated by the correct arrow, and they must be impermeable. Newly installed filter elements should first pass through the maximum flow of water for at least five minutes (referred to as “activation”) to filter the air in the filter elements and lines, and apply the microscopically purified patent formula to the multi-pleat filter element. , to get the best filtration effect and extend the life of the filter.

When the raw water output becomes too small (multiple pleated filter body is saturated) or the filtered water has an odor (the micro-purification patent formula is saturated), the filter element should be replaced. The time is based on the local water quality and hygiene. The amount of drinking machine may vary. The saturation time of the micro-purified patent formula and multi-pleated filter body will be different depending on the water pollution situation in different regions, and the saturation may be different in different regions.

The filter of the pre-filter is recommended to be replaced at least once every six months to maintain and prolong the service life of the drinking fountain filter. The filter element of the pre-filter is forbidden to wash with water. If raw drinks and pre-filters are dirty, do not use alcohol, banana water or other chemical reagents. Simply wipe with a damp clean towel.