The car engine is the most important power system of the car. The components inside are also very tight and can not be damaged. The air filter is a part of the engine protection, so the air filter needs to be replaced or maintained regularly. Here are some of the relevant knowledge about air filters that Xiaobian has compiled for the riders. It is equivalent to the human nose, the “level†of the passage of air into the engine. The function is to finely filter the air entering the engine cylinder, filter out the sand in the air and some suspended particles, so that the air entering the engine is compared. Pure, so it is especially important for its maintenance. Below I am here to check the maintenance method of the air filter for everyone, I hope to be helpful to the majority of car owners. Regularly clean the air conditioner filter If the air filter is the "nose" of the car, then the air conditioner filter is directly related to whether the nose of the passenger in the car can breathe healthy air. The air entering the interior of the compartment from the outside is filtered to improve the cleanliness of the air and ensure the health of the passengers inside the vehicle. It is important to keep the air conditioner filter clean if the vehicle frequently passes through dusty roads. In the colder temperatures in winter, some car owners close the windows when driving, only open the inner circulation and do not open the air conditioner. The master pointed out that this is not correct. After a long time driving, the air inside the car will be turbid. Health brings certain hidden dangers. Normally, when the vehicle travels 8,000 km to 10,000 km, the air conditioner filter needs to be replaced once. Usually, it only needs to be cleaned regularly during each season, especially after the winter. Air conditioner filters can also be cleaned by yourself, which is not difficult. How to maintain the air filter? According to the maintenance cycle of the vehicle, in the case of general roads, the air filter should be cleaned and maintained every 5,000 kilometers. In areas with large dust and sand and poor ambient air quality, the maintenance interval should be shortened accordingly. The master recommends cleaning up every 3,000 km in advance. The air filter of a general car should be changed once when the car is driving 20,000 kilometers. DIY clean air filter Preparation tool: screwdriver 1. Stop the fire and stop. Make sure the vehicle is turned off and cool for 15~20 minutes, then open the engine compartment cover and locate the air filter. The air filter is usually located on the right side of the engine compartment and can be found in the vehicle's manual. 2. Take the filter. Open the filter cover latch, remove the nut that secures the cover, pull the bezel open, and remove the filter element. When removing the filter element, take care to prevent impurities from falling into the carburetor. 3. Clean the filter element. Check the filter element for more dust. You can gently tap the end face of the filter element. You can use compressed air to blow off the dust from the filter element. If there is no compressed air, tap the filter element with a screwdriver handle and brush the external dirt with a brush. Never use petrol or water wash brushes. If the air filter has been severely blocked, it needs to be replaced with a new one. 4. After the filter element has been cleaned, install the parts in the reverse order of removal. The air filter is the last level of the engine, the key to protect the engine from damage, so the riders must pay attention to the maintenance of the air filter.
The Tiema Hose Protection Sleeve is the culmination of decades of experience in the Hydraulic Hose and hose fittings industry. Ourhydraulic hose protector are designed to meet the most stringent of international safety standards, whilst also actively preventing rubber hose damage and potential injury.during the construction process, the hydraulic pipe without the protective sleeve is hit and bursts or the pressure of the hose itself bursts due to excessive pressure. The hydraulic oil in the pipe may leak and cause the machine to be contaminated. On the one hand, the hydraulic hose sleeve can prevent the hose from being injured. And spiral guard can also prevent the hydraulic oil from splashing around after the hose itself bursts.
Hydraulic Hose guard Key Feature:
• High abrasion resistance
• High flexibility
• Resistant to water, oils, fuels and hydraulic fluids
• Easy to install, no clamps needed
• High ozone and external agents resistance.
Hose Protection Sleeve,Hose Protection,Hose Spring Guard,Hose Protection Spring Luohe Tiema Hydraulics CO.,Ltd , https://www.hydraulichosesdirect.com
September 03, 2024