Feed Crusher Wood Chip Crusher Hammer Crusher Dual Port Wood Crusher

Multi-function wood cutting machine Wood crusher Wholesale sawdust crusher price Sawdust mill is an ideal mechanical equipment for the efficient production of sawdust, this machine can be a variety of wood, wood waste, branch fork, wood chips, board edge material , Bark, bamboo, bamboo and other raw materials processed into sawdust, wood-like products, with less investment, low energy consumption, high productivity, good economic returns, ease of use and maintenance. The smashed wood chips have small grain size, obvious wood fiber, and even material discharge. The whole set of equipment is driven by a single motor, simple structure, compact layout, low price, stable operation, low energy consumption, high output, and wood chips Good quality.

Multi-function wood cutting machine Wood crusher Wholesale wood crusher price Sawmill pulverizer is a new type of wood production series before the ideal production of woodworking machinery and equipment. The wood shredder components consist of mainly organic shells, bearings, screen meshes, transmission wheels, and troughs. All materials are cast from manganese steel. The wood crusher consists of a body, a middle body, and a lower body. The mid-body body is equipped with a triple stator large circle, a crusher head, and a fineness analyzer. The host uses alloy heads. It has a high degree of wear resistance and thus also increases the yield. The motor drives the high-speed operation of the pulverizer rotor, so that the machine generates high-speed airflow to produce high-strength impact force, compressive force, and cutting force on the pulverized materials and achieve a unique crushing function.

Crusher product parameters:

Single port

Hammer smash

Two-port multi-function type:

Instructions for use
1. Turn on the power and see if the steering is correct. ;
2. When the tool is changed, the knife edge extends 2-4mm from the plane of the cutter head and tightens the bolt. If it is found that the pressure screw thread is worn, it should be replaced immediately to prevent damage to the sliding disk nut. ;
3, change the degree of expansion of the knife must be consistent with the length of the knife. ;
4, by adjusting the knife length, when the particles can not reach the ideal, change the different diameter of the Luo Si. ;
5. It is forbidden to put firewood with stones and nails into the machine to prevent the knife and internal parts from being damaged. ;
6, pay attention to check the hammer bolt, found loose, and immediately tighten, hammer and bolt wear serious, should be replaced. ;
7. The sharpening angle is a straight line of 28-30°. It is forbidden to grind into a convex surface. The convex surface will cause the steel blade to break away or part of the steel to be removed. ;
8, the regular use of the machine should check the lack of bearing grease. The butter should be filled once every 3-4 hours. It is not easy to add butter. ;
Instructions
1, the use of this machine, without changing the power and speed, grinding angle, to maintain the original straight line 28-30 degrees.
2, change the particles, need to change Luo, adjust the knife at the same time, Luo Kong minimum is not less than 14mm (diameter), the maximum is not more than 20mm (diameter), adjust the knife length between 3-6mm, the gap between the knife and the knife is not greater than 1mm.
3, the function of the powder diameter of 3cm-20cm below the wood into particles.