If you want to buy a tanker, you have to determine what tonnage you want. If you want between 3 tons and 8 tons, you can choose Futian Xiaoka, Dongfeng Jinba, Foton Aoling, etc. Wait. If you want between 8 tons and 15 tons, you can choose Dongfeng Houqiao, Dongfeng Tip, Dongfeng Pingtou or Fukuda Yuwei and so on. If you want to be more than 20 tons, then you can choose after the liberation of Shuangqiao, Dongfeng Tianlong, Auman post-Shuangqiao, Dongfenghoushuangqiao, and so on. The engine and site mentioned above are: Yuchai, Chaochai, and Xichai. Then when using a tanker , notice the following precautions and preparations: 1. It should be carefully checked whether the electrostatic connecting device of the tanker has been damaged or broken. Check if there is abnormality in the contact of the car body. 2. Carefully check whether the valves of the oil tanker tubing are all in good condition and whether the valve is loose. 3. When the vehicle is used for the first time, it is necessary to check if there is oil added in the pump. 4, the need to regularly check the gear in the gearbox under the vehicle is not enough, if the lubricant is insufficient, it should be added in a timely manner, so as to avoid the vehicle's various shaft teeth caused by the wear and tear caused by the occurrence of failure . 5. After each use, it is necessary to check whether the power take-off and valve operation switches are reset. 6. Carefully check if there is any blockage between the various oil circuits. 1. What are the inspection preparations that the tanker should do before refueling? 1. Before operating the tanker, it is necessary to check the attention of the vehicle. When the conductive rod is inserted into the ground, it can be grounded to conduct electricity. If it is too dry, it can be watered to make it wet. Then check that there is no ground contact in the lower ground. 2. Open the valve and check if the oil in the pump is sufficient. If it is not enough, add it immediately. If there is no oil, inject about 10 liters into the oil inlet. 3. Check whether the oil surface of the oil in the gearbox of the tanker has reached the bottom of the bolt. Second, the oil tanker pump power take-off operation 1. After starting and connecting the relevant channels, start the engine. When the pressure gauge of the original vehicle reads 0.3mpa, press the clutch pedal, open the power switch operation switch, and then slowly release the clutch. To make it a file. 2. The throttle controller can be used to control the operating speed of the oil pump. 3, stop the throttle controller. Adjust it to a minimum, then remove the clutch pedal and turn the power take-off switch back to its original position and disengage it. (Text / Sun Ni)
Ford tractor was established in 1920s, and produced a lot of famous tractor model, like 2N, 8N, 9N, 6000, 7000, 8000 series. But in 1990s, Ford management decided to focus on automobile market, so they sold the tractor business to Fiat. The parts for Ford we can offer are some engine aftermarket parts, like motor starter, alternator, fuel pump. Due to the getting less for the Ford tractor market holdings, the related spare parts are also hard to find. But our group can develop and manufacture the parts for Ford, like the muffler, front glass, wiper blade, wiper motor. They all could be made by us.
Besides, our company have been in the market of replacement spare parts for over 10 years, we know how to manage the quality control. It is reliable to find us for establishing cooperation.
Ford Aftermarket Parts,Custom Car Parts,Ford Skid Steer Parts,Ford Equipment Hangzhou Holdwell Mechanical&Electrical Co.,LTD , https://www.holdwellparts.com
September 16, 2019