After the flotation machine is overhauled, the flotation cell should be carefully inspected and cleaned before the test, and then the empty car test run, and gradually added to the clean water operation. Pay attention to adjust the size of the circulation hole during operation. At the same time, pay attention to check whether the impeller has bias and impact. Also pay attention to whether the operation sound of each part is normal. When starting the motor, check the direction of rotation of the motor shaft. It must be ensured that the impeller shaft rotates clockwise (top view). The following parts should be checked frequently during operation: (1) Overheating of rolling bearings in electric motors and impeller bodies. Generally, the bearing temperature must not exceed 35 ° C, and the maximum temperature must not exceed 65 ° C. (2) Check the tension of the drive belt, and the degree of tightness should be appropriate. When serious wear is found, the belts of the same length and type should be selected in time to be replaced in groups. (3) Check the tightness of the oil seal rubber ring. In particular, it should be noted that the lubricating oil in the bearing body should not leak into the slurry, so as not to affect the normal operation of the flotation process. (4) Check if there is enough grease at each lubrication point. If it is found that there is less oil, it should be added in time. (5) Check for any other debris in the flotation tank and clean it in time. Buy auto parts mold, electric motorcycle mold, food container mold, chair molding machine Turn Machine (Zhejiang) Co., Ltd , https://www.plasticblowing.com
April 22, 2024